Pilot Light On Gas Fireplace Went Out

Here’s What to Do When Your Pilot Light Goes Out on Your Gas Fireplace

A gas fireplace can be a great way to add warmth and ambiance to your home. But what happens when the pilot light goes out? Don't worry, it's a relatively easy fix that you can do yourself. Here are the steps on how to relight the pilot light on your gas fireplace:

1. Safety First

Before you start, make sure that the gas valve is turned off. This is usually located near the bottom of the fireplace. Once the gas valve is off, wait a few minutes for the gas to dissipate.

2. Locate the Pilot Light Assembly

The pilot light assembly is usually located near the bottom of the fireplace, behind a small access panel. Once you've located the pilot light assembly, remove the access panel.

3. Light the Pilot Light

Use a long lighter or match to light the pilot light. Hold the flame to the pilot light for about 30 seconds, or until the pilot light stays lit on its own.

4. Reassemble the Pilot Light Assembly

Once the pilot light is lit, replace the access panel. Make sure that the panel is securely fastened.

5. Turn on the Gas Valve

Once the pilot light is lit and the access panel is replaced, you can turn the gas valve back on. Slowly open the valve until you hear the gas flowing.

6. Adjust the Flame

Once the gas is flowing, you can adjust the flame to the desired height. To do this, use the adjustment knob located on the fireplace.

Conclusion

Relighting the pilot light on your gas fireplace is a relatively easy task that you can do yourself. By following these steps, you can get your fireplace up and running again in no time.