Heatilator Gas Fireplace Pilot Light Out Of Sync With Timer

A Heatilator gas fireplace is a great way to add warmth and ambiance to your home. However, if the pilot light goes out of sync with the timer, it can be frustrating. Here are a few tips on how to fix the problem.

1. Check the batteries. The first thing you should do is check the batteries in the timer. If they are low or dead, the timer will not be able to send a signal to the pilot light to turn it on.

2. Clean the pilot light assembly. Over time, the pilot light assembly can become dirty or clogged with debris. This can prevent the pilot light from igniting properly. To clean the pilot light assembly, remove the front panel of the fireplace and use a soft brush to remove any dirt or debris.

3. Reset the timer. If the batteries are good and the pilot light assembly is clean, the next step is to reset the timer. To do this, turn the timer knob to the "off" position and then back to the "on" position. This will reset the timer and send a new signal to the pilot light.

4. Replace the thermocouple. If the pilot light still does not ignite after resetting the timer, the thermocouple may need to be replaced. The thermocouple is a small device that senses the presence of a flame and sends a signal to the gas valve to open. If the thermocouple is faulty, the gas valve will not open and the pilot light will not ignite.

5. Call a qualified technician. If you have tried all of the above steps and the pilot light still does not ignite, it is best to call a qualified technician. A technician can diagnose the problem and make sure that the fireplace is operating safely.