Fireplace Pilot Light Went Out

Fireplace Pilot Light Went Out: Essential Information and Troubleshooting

A fireplace provides warmth and ambiance to your home, but it can be frustrating when the pilot light goes out. This guide will provide you with the essential information and troubleshooting steps to get your fireplace up and running again.

What is a Pilot Light? A pilot light is a small flame that continuously burns in your fireplace, even when the main burners are off. It serves as an ignition source, lighting the gas when you turn on the fireplace.

Why Does the Pilot Light Go Out? Several factors can cause the pilot light to go out, including:

Gas supply interruption
Clogged gas lines
Dirty or blocked pilot assembly
Drafts or strong winds
Faulty thermocouple or flame sensor

Troubleshooting Steps

Before attempting any troubleshooting, ensure that the gas supply is turned on and that there are no obstructions blocking the fireplace opening.

1. Check for Gas Supply a. Turn off the fireplace and wait a few minutes. b. Close the gas valve. c. Wait 5 minutes and then turn the valve back on. d. Relight the pilot light. 2. Clean the Pilot Assembly a. Remove the pilot assembly from the fireplace. b. Use a wire brush or pipe cleaner to clean the pilot orifice, thermocouple, and flame sensor. c. Ensure all parts are dry before reassembling. 3. Inspect the Thermocouple or Flame Sensor a. The thermocouple or flame sensor may become dirty or faulty. b. Test the thermocouple by holding a lighter flame near the tip while it is connected to the fireplace. If the flame does not light, replace it. c. Replace the flame sensor if it is cracked or broken. 4. Address Drafts or Winds a. Drafts or strong winds can blow out the pilot light. b. Install a windguard or draft stopper around the fireplace opening. 5. Call a Professional If the above steps do not resolve the issue, it may be necessary to call a qualified fireplace technician. They can diagnose the problem and make necessary repairs or replacements.