Heatilator Fireplace Pilot Light Out

Troubleshooting a Heatilator Fireplace Pilot Light Out

If the pilot light on your Heatilator fireplace goes out, it can be frustrating and leave you without a warm and inviting fire. Troubleshooting the issue and relighting the pilot light is a relatively simple process that can be done in a few steps.

Safety First

Before you begin any troubleshooting, it's important to ensure your safety. Make sure the fireplace and surrounding area are cool to the touch. Turn off the gas supply to the fireplace and allow it to cool for at least 30 minutes.

Inspect the Thermocouple

The thermocouple is a safety device that shuts off the gas supply if the pilot light goes out. Inspect the thermocouple for any damage or corrosion. Replace the thermocouple if it appears damaged.

Clean the Pilot Assembly

Over time, dust and debris can accumulate on the pilot assembly, preventing it from functioning properly. Use a soft brush or compressed air to clean the pilot assembly and any surrounding areas.

Check the Gas Supply

Ensure that the gas supply to the fireplace is turned on. Check the gas valve and make sure it is in the "open" position. If you are using a propane tank, verify that the tank has sufficient propane and is properly connected.

Relight the Pilot Light

Once you have checked and cleaned all the necessary components, you can attempt to relight the pilot light. Follow the instructions provided in your Heatilator fireplace manual. Typically, you will need to press and hold the pilot ignition button while simultaneously turning the gas valve to the "on" position. If the pilot light does not ignite, repeat the process.

Additional Tips

If you are still unable to relight the pilot light, it may be necessary to call a qualified technician for further assistance. They can inspect the fireplace and determine if there are any underlying issues that need to be addressed.

To prevent future issues with the pilot light, regular maintenance is recommended. This includes cleaning the fireplace and pilot assembly, inspecting the thermocouple, and ensuring that the gas supply is functioning properly.